Moo
Guitar Service Manual
Example
Install the two blade switches with their circuit boards facing the outer rim of the
guitar. Please be sure the three position and five position switches are in the correct
location (see Fig C).
Install 4 machine screws for switches. Please be extra cautious to not over tighten
these screws. The switch will strip out and the guitar finish will get damaged. Make
sure all four screws are fully plated, without patches where black oxide has worn
off.
Install three position gold plated toggle with two small lock washers. This should
leave enough bushing to add one gold plated flat washer and one gold plated nut
one the outside of the guitar, without extra threads being visible.
Orient toggle so the white wire is closest to pick up cavities. Carefully tighten nut.
Please not over tighten, or mar the nut. This will not be covered with a knob and
needs to sta
cosmeticall
intact.
To Next Page
Loading...