27
© 2003 Skier’s Choice, Inc.
Navigation Lights
The navigation light switch supplies power to the Bow Light,
the Stern Light and the Pole Light.
Operation: When under way at night install the Pole Light
and set the switch in the NAV position to activate all of the
running lights. When docked or at anchor at night set the
switch in the ANC position to illuminate only the pole light.
NOTE: If lights fail to operate, press the circuit breaker
reset button located above or beside the lights switch.
Bilge Pump Switch
The bilge pump switch operates in two positions. The manual
position is used to verify that the pump is operational.
The automatic pump function is engaged at all other times
so that any excess water in the bilge may automatically be
pumped out.
NOTE: If the Bilge Pump fails to operate in the manual
position, press the circuit breaker reset button labeled BILGE
on the circuit breaker panel under the dashboard. If the bilge
pump still does not operate, notify your Moomba dealer.
Warning Light (V-Drives Only)
The warning light should be “on” at idle. If the light remains
“on” when the engine is above 1200 RPM, shut the engine
off and check V-Drive oil level.
To Next Page
Loading...
