36
© 2003 Skier’s Choice, Inc.
To Lower Cage for Storage:
To Raise Cage:
Tools required: 5/16” Allen wrench (for stainless steel 3/8-16
X 1-14” Allen head bolt)
- Loosen, but DO NOT remove front leg allen bolts.
- Loosen and remove the hand-knob bolts that connect the
rear legs to the feet.
- Place the hand-knob bolts somewhere for safe storage.
- While standing in the bow area, pull the cage forward,
gently placing it against the bow of the boat.
Place padding between the cage and the boat to protect
the gel coat.
- Lift and rock the tower back into place until the rear legs
align with the rear feet. (Some manipulation of the cage
may be required to get the legs to line up with the feet.)
- Install and tighten the rear head-knob bolts
- Tighten the front leg’s allen bolts.
The threads in the aluminum foot could be damaged if
the bolts are not aligned and threaded correctly.
Rad-A-Cage is designed to pull - single (1) wakeboarder,
trick skier, or kneeboarder.
Rad-A-Cage
The Mobius models are equipped with a
Moomba Rad-A-Cage towing tower. The
cage is designed as a stable tower to
enhance wakeboarding. It is NOT intended
to be used to tow skiers, barefooters, or
multiple wakeboarders. Such use will void
any warranties written or implied.
Before use, be sure that all bolts are
tightly in place.
Be aware of and avoid low overhead
objects such as bridges, power lines,
overhanging trees, etc.
Pop-Up Cleat
To use the cleat, pull center up.
DO NOT tow objects with the cleats.
To Next Page
Loading...
