Ccntents:
LUNAR
*CR2032 battery x 2
*RB-22 (Universal bracket)
*2 O-rings for mounting:
RS-G (fits 20-35mm diameters)
RS-H (fits 35-52mm diameters)
*BK-21 (Belt clip)
Optional acessoires:
*RB-19 (Rear rack mount bracket)
*RB-21 (Saddle rail bracket)
*RB-23 (Helmet bracket)
*1 pc (15 chips) COB high brightness red LED
*CR 2032 battery x 2
*5 modes: High / Over drive /
50% Flashing / 100% Flashing / Strobe
*Quick release universal bracket RB-22
(fits all round bars and AERO style bars)
*2 O-rings for mounting: RS-G (fits 20-35mm diameters)
RS-H (fits 35-52mm diameters)
*Side visibility
*Water resistant (IPX 4)
*Belt clip design
(can be installed either on saddle bag, jersey back pocket, etc.)
1. Press the power button to choose the modes:
In this method two modes are cycled.
LIGHT OPERATION
HOW TO MOUNT THE LIGHT
USER GUIDELINE
Thank you for choosing MOON light!
*For using this product safely and conveniently and keeping it
well-preserved, please read this manual carefully before using.
Please save this manual for future reference.
*Due to the improvement of the product, the product you bought may
not be exactly in accordance with the introduction of this manual. We
apologize for that.
SPECIFICATION
CONTENTS INCLUDED
2. Fast press two times the power button to change into the strobe
and flashing modes. Fast press two times back to the first cycle.
5. When the LED is not bright enough, it means the batteries are low.
You'd better change the batteries right now.
* Change the batteries
4. Press and hold the on / off button around 0.5 seconds to turn off.
Dim
High beam
Standard
High beam
Standard
Strobe
100% Flashing
50% Flashing
Hold 0.5 sec
PRESS
Power button
PRESS
Power button
PRESS
Power button
PRESS
Power button
RELEASE
clockwise
anticlockwise
1. 2.
Method 1
®
Fast press
2 times
Fast press
2 times
Fast press
2 times
2. Fast press two times the power button to change into the strobe
and flashing modes. Fast press two times back to the first cycle.
HOW TO MOUNT THE LIGHT
1. Choose the strap to fit in the bar.
2. Make sure the strap is click in place of the hook.
3. Hold the light on the seat post.
4. Wrapping rubber strap around bar and stretching strap around hook to secure.
5. Slide the light forward onto bracket until it clicks into place.
6. Press down release lever to remove.
Pull
Install
7. Adjust the vertical beam angle when mounted on the seatpost, loosen
the screw knob band the light up or down for your preferred angle, then
tighten the screw knob to secure the light in place.
Install
Release
click
Press
Wrapping
Release
Adjust
RS-G RS-H
35-52 mm20-35 mm
20-26 mm
26-35 mm
26-35 mm
35-52 mm
1.Slide tail light forward onto belt clip until it clicks into place.
2.Press down release lever to remove.
Install
Press
click
Release
Method 1
Method 2
To Next Page
Need help?
General
