EasyManua.ls Logo

MOONRAYS 95432 User Manual

MOONRAYS 95432
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
OUTDOOR LOW VOLTAGE TRANSFORMER INSTALLATION AND USE
(12 volt lighting systems)
MODEL NO: #95432 200 Watts Maximum (PTST-20012)
120 Volt Power Cord, 12 Volt Output
Light can be operated 3 ways:
1. Light fixtures will automatically come ON at dusk and OFF at dawn or when the unit senses the absence
of light for more than 30 seconds
2. Timer can be set for 1-9 hours of operation. Settings will repeat every 24 hours
3. Turn fixtures on and off manually
Installation Instructions: Outdoor Only
Install 2 screws into wall 8cm apart and at least 12” above ground. Hang the transformer on the screw heads.
Determine the low voltage wire gauge required for installation. Carefully remove 1” of plastic jacket from the wire
ends.
As shown in the illustration loosen screws on back of transformer and wrap the wire around each screw head,
tighten screws securely. Connect each light fixture.
Operating Instructions:
Once installed correctly, open front cover and plug into a 120 volt GFCI-protected receptacle. Bulbs must be 12
volt. Press the UP and DOWN arrows next to the LED display until the desired setting is reached - Display will
show:
“O” ON
“A” Lights will automatically come ON at dusk and OFF at dawn or when the unit senses the absence of light
for more than 30 seconds
“1-9” 1-9 hours of operation - Lights will automatically come ON at dusk and remain on for the number of hours
selected.
Troubleshooting:
- Adjust display to “O” (ON)
- Place the transformer in a location free of obstructions such as shrubbery
- The photo sensor will not activate if another light source is shining on the transformer. Remove the extra light
source.
- Total bulb wattage cannot exceed the transformers wattage. If necessary remove extra bulbs.
Circuit breaker protectionin case of power overload, the lights will automatically shut off. Press reset button
to reset circuit breaker if necessary. If the unit does not have power, try the following solutions:
o Make sure plug is securely plugged into a GFCI-protected receptacle
o Check connection between low voltage cable and transformer to make sure it is secure - if a
loose connection is found, reconnect and tighten screws securely
If these solutions do not work, contact 1-800-561-4321 (Consumer Helpline) or visit www.moonrays.com
and
choose the Customer Service web page.
295725-08
Question and Answer IconNeed help?

Do you have a question about the MOONRAYS 95432 and is the answer not in the manual?

MOONRAYS 95432 Specifications

General IconGeneral
BrandMOONRAYS
Model95432
CategoryTransformer
LanguageEnglish

Summary

Outdoor Low Voltage Transformer Installation and Use

Light Operation Modes

Defines three modes: automatic dusk-to-dawn, timer-based, and manual control.

Outdoor Installation Instructions

Step-by-step guide for mounting the transformer and connecting low voltage wiring.

Operating Instructions and Settings

How to plug in, use display settings (O, A, 1-9), and bulb requirements.

Troubleshooting Common Issues

Addresses photo sensor obstruction, location, and wattage limits for optimal performance.

Circuit Breaker Protection and Power Issues

Explains overload protection, reset button, and checks for power loss or connection problems.

Related product manuals