13
Manual. Insert the key into the lock and turn it counter clockwise to unlock the door. To lock the door do the
reverse operation making sure metal pin is engaged completely. Remove the key and place it in a secure place
for safekeeping.
Cleaning your wine chiller
Turn off the power, unplug the appliance, and remove all items including shelves. Wash the inside surfaces with a
warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to 1 cup of
water.
Wash the shelves with a mild detergent solution. Wring excess water out of the sponge or cloth when cleaning
area of the controls, or any electrical parts.
Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a cl
ean soft
cloth. Do not use steel wool or steel brush on the stainless steel. These will contaminate the stainless steel with
steel particles and rusting may occur.
Shelves
This appliance is equipped with a telescopic runner assembly (except for the bottom shelf) and you can move the
wooden shelves out and in smoothly.
To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of
the rail compartment. For easy access to the bottles, you must pull the shelves approximately 1/3 out of the rail
compartment.
To remove the shelves out of the rail pull each shelf approximately 1/3 out. Use a long flat screwd
river to press
down the right plastic notch as shown in Figure A and at the same time lift the left plastic notch as shown in Figure
B. Then proceed to pull out the shelf slowly.
Figure A Figure B
To Next Page
Loading...
