Need help?Do you have a question about the MOOV Ai Series and is the answer not in the manual?
Covers general warnings, GFCI requirements, cord replacement, and pool types.
Addresses enclosure, bonding conductor, and distance from pool.
Specifies pool types, permanent installation, and avoiding extension cords.
Includes dry run, servicing, tightening screws, and clearing blockages.
Guidance on optimal placement for efficiency and cooling.
Advice on pipe size, suction line, valves, and check valves.
Specifies elbow placement, union sizes, and check valve usage.
Steps to verify pump shaft rotation, voltage, frequency, and motor direction.
Lists environmental and operational parameters like temperature, humidity, and installation height.
Explains the icons and indicators on the pump's control panel.
Details the initial power-on sequence, screen locking, and unlocking.
Describes automatic and manual self-priming process and settings.
Instructions for initiating and exiting backwash mode, including setting range.
Explains the easiest operating mode for manual capacity adjustment.
For advanced users, explains automatic system pressure adjustment and flow rate setting.
How to program on/off times and running capacity/flow rate daily.
Procedures for preparing the pump for cold climates and warranty exclusions.
How to restore factory settings, check software, and enter parameter settings.
Instructions for downloading the app on Android and iOS.
Steps for registering an account via email or third-party apps.
Details registration via Facebook or Google accounts.
Guides on naming the home and setting device locations within the app.
Step-by-step guide to connect the pump to the app using Wi-Fi and Bluetooth.
Alternative method for pairing the pump using Wi-Fi only.
Details the connector for configurable inputs and AC power input.
Explains the use of relay output and AC power input for external control.
How digital inputs determine running capacity and control modes.
How to connect and control the pump via Modbus 485 protocol.
How to enable external control using relay output and necessary components.
Explains the high-temperature warning trigger, release thresholds, and speed reduction.
Details how the device limits running speed based on input voltage levels.
Lists common issues like pump not starting, not priming, low flow, and noise with causes and solutions.
Lists various error codes (E001-E209) and their descriptions.
Instructions for emptying and inspecting the strainer basket and its lid.
General| Brand | MOOV |
|---|---|
| Model | Ai Series |
| Category | Swimming Pool Pump |
| Language | English |
To Next Page
