Parts Included:
Installing the handles
8
NOTE:
Handle mounting setscrews are
preinstalled inside the handle.
2. Open a refrigerator compartment door.
On the closed door, place a handle
onto the shoulder screws so that the
setscrews are facing the adjacent door.
3. Firmly push the handle toward the door
until the handle base is flush against the
door.
4. While holding the handle, insert the short
end of the allen wrench into the upper
hole and slightly rotate the hex key until
it is engaged in the setscrew.
10. Firmly push the handle toward the drawer
until the handle base is flush against the
drawer.
11. Insert the short end of the allen wrench into
the left-hand hole and slightly rotate the allen
wrench until it is engaged in the setscrew.
1. Remove the handles from the package
inside refrigerator, and place them on
a soft surface.
12. Using a left to right motion tighten the
setscrew a quarter-turn at a time just until
it begins to contact the houlder screw.
Do not fully tighten.
13. Repeat steps 11 and 12 to fasten the right
-hand setscrew to the shoulder screw.
14. Once both setscrews have been partially
tightened as instructed in the previous
steps, fully tighten both setscrews.
15. For some models, repeat steps 9 through 14
to install a handle on the second drawer.
16. Save the allen wrench and all instructions.
IMPORTANT:
When the screws feel tight, tighten
them an additional quarter-turn. The handle is
not properly installed without this extra tightening.
5. Using a clockwise motion tighten the
setscrew just until it begins to contact
the shoulder screw.Do not fully tighten.
6. Repeat steps 4 and 5 to fasten the lower
setscrew.
7. Once both setscrews have been partially
tightened as instructed in the previous
steps, fully tighten both setscrews.
8. Repeat steps 2 through 7 to install the
other handle onto the adjacent
refrigerator door.
9. With the freezer drawer closed, place the
handle onto the shoulder screws so that
the setscrews are facing down toward
the floor.
A. Shoulder screw
B. Setscrews insidethe
handle
A. Shoulder screw
B. Setscrews insidethe handle
Remove the Handles
1. While holding the handle, insert the short
end of the allen wrench into a setscrew
hole and slightly rotate the hex key until
it is engaged in the setscrew.
2. Using a right to left motion loosen the
setscrew a quarter-turn at a time.
3. Repeat steps 1 and 2 for the other
setscrew. Slowly pull the handle away
from the door or drawer.
4. If necessary, use a Phillips screwdriver to
remove the shoulder screws from the door.
Door handles
(
3
), Allen wrench
To Next Page
Loading...
