MAINTENANCE GUIDELINES
It is the responsibility of the user to perform periodic maintenance
procedures to insure that your table remains in optimum service for many
years. The factory recommendation is towards a twelve week cycle of
attention. The procedure should only take a small amount of time and is
quite straight-forward. During the maintenance procedure take care to detach
the table from the mains power supply whilst cleaning and re-attach the table
for the portions of the procedure that involve table movements.
Do not access any the internal cavities of any control box or electrical
assembly. Do not reach under the table top during any motion instigated by
the controller(s). Do not sit or lay on the table during the procedures.
To Next Page
Loading...