36
Lights and Indicators
The lights and indicators are operated from the left hand stalk behind the
steering wheel. This stalk includes an inner ring for fog lamps and an outer
ring for driving lamps.
Indicate Left: push the stalk in a downward direction.
Indicate Light: lift the stalk in an upward direction. Indicators are self
-
cancelling.
Lane Change Function: press the lever as far as the resistance point; the turn
signal indicators flash three times.
Side Lamps: rotate the outer end of the stalk to the first position.
Headlamps: rotate the outer ring of the stalk to the second position.
High Beam: pull the stalk towards the steering wheel past the point of resistance.
Low Beam: pull the stalk back towards the steering wheel past the point of resistance.
Flash Headlamps: lightly pull the stalk towards the steering wheel, then release.
Turn off the automatic switching of dipped beam headlamps: press and hold
the left stalk button for 2 seconds with the indicator stalk outer ring set to
switch position 0. The automatic switching of dipped beam headlamps will be
turned back on by default on the next ignition cycle.
Welcome Lights: Upon unlocking the vehicle the exterior and interior lights
will illuminate for 60 seconds.
Courtesy Lights: After turning off the ignition, if it is dark outside, the
headlights will remain illuminated for 60 seconds.
If the vehicle is left with side lamps or headlamps illuminated, a sound will
emit to alert the driver that the lights have been left on. In the event of light
module failure, an amber warning symbol will illuminate. If this shows, stop
the vehicle when it is safe to do so and check the operation of the front and
rear lights, proceed with caution and report this to a Morgan dealer as soon
as possible. If there is a complete light failure of all the lighting circuits, do not
drive the vehicle and contact the nearest Morgan dealer to rectify.
Windscreen Wipers/Washers
The right hand stalk behind the steering wheel operates the wiper and washer
system. To operate the wipers move the control upward.
Position 1: Wipers Off Position 2: Intermittent Wipe
Position 3: First Speed Continuous Position 4: Second Speed Continuous
When in position 3 or 4, the wipers automatically change their speed down
to the position below the previous selection when the vehicle speed reaches
1mph or below. Once the speed increases above 1mph the setting previously
selected resumes.
Intermittent Wipe / Single Wipe
With the main switch in the second position, the windscreen will be cleared
after a pre-set delay. If the complete stalk is pressed downward, the windscreen
will be swept once. The stalk will return automatically.
Windscreen Washers
To wash the windscreen, the stalk should be pulled towards the steering wheel.
The stalk will return automatically. Each time the washer is operated, the
wipers will sweep the windscreen four times.
WARNING Always switch the wipers off before turning off the ignition.
WARNING In frost or snow, always check that the wipers are free before
operation. Not doing so will damage the wiper system.
WARNING At all times use an additive in the windscreen washer system
to prevent freezing.
WARNING Do not use wipers on a dry screen.
LIGHTS, INDICATORS AND WIPERS
To Next Page
Loading...
