Plus Line Owner’s Handbook - Version 1.0
37
Ignition Switch/Steering Lock
The ignition switch is located on the steering column and has 3 positions.
1
st
Position: Steering wheel lock in operation and ignition off, key can be
extracted in this position.
2
nd
Position: Ignition switched on.
3
rd
Position: In this position, press and hold the start button whilst pressing
the brake pedal (automatic) or clutch pedal (manual)
to start the engine.
WARNING Never allow the car to move unless the lock is deactivated.
Failure to unlock the steering may result in an accident resulting in serious
injury or even death.
Daytime Driving Lights
In some countries daytime driving lights are compulsory. Daytime driving lights
illuminate automatically when ignition is on.
Side Lights
Rotate the indicator stalk outer ring to the position.
CAUTION Do not leave the side lights on for long periods of time when
the engine is not running. Doing so will discharge the battery and may leave
insufficient power to allow the engine to be started.
Headlamps
Rotate the indicator stalk outer ring to position . Select between high and
low-beam by pulling the Indicator stalk towards the steering wheel.
LIGHTS, INDICATORS AND WIPERS
Automatic Switching of Dipped Beam Headlamps
Depending on ambient brightness, the system switches the low-beam
headlights on or off automatically. The headlights may also come on when the
sun is setting low in the sky. The driving spot lights will function as part of the
automatic switching of dipped beam headlamps.
To turn off the automatic switching of dipped beam headlamps, the Indicator
stalk outer ring should be set to switch position 0. Press and hold the indicator
stalk button for 2 seconds to toggle the icon on and off in the Driver
Information Panel behind the steering wheel. The automatic switching of dipped
beam headlamps will be turned back on by default on the next ignition cycle.
Rear Fog Lamp
Twisting the inner collar of the indicator stalk upwards turns on the rear fog
lamp. Headlamps must be on for the fog lamps to turn on. When turned on, a
symbol will display on the Driver Information Panel. The rear fog lamp will only
operate when the vehicle lights are switched on.
NOTICE Do not use rear fog lamps in good weather conditions, use only
when necessary.
Beam Deflectors
If your vehicle requires modification for driving on the opposite side of the road
for which it was manufactured, Morgan recommends that the correct headlights
are purchased and installed on the vehicle by a Morgan trained technician.
Morgan acknowledges that correctly positioned after-market beam deflectors
may prevent glare to oncoming drivers, though these are likely to obscure the
day-time running lights.
To Next Page
Loading...
