Congratulations on purchasing your new Morgan
Amp!
Joe Morgan started designing amplifiers to create
solutions to the problems he was facing as a
guitarist.
A good customer brought in a really expensive
vintage amplifier into the Morgan shop and asked
for an updated version. This 50 watt 6L6 amplifier
was based around this 40 year old piece of history.
The original needed to have some updates to
make it easier to use with today’s guitars and
pedals. The result is the SW50. This amp produces
a sweet singing sustain even on clean notes.
Intentionally designed to be the loudest cleanest it
could be with 2x6L6s it is still capable of producing
a warm compressed natural overdrive.
The SW50takes pedals very well and loves Fuzzes,
boosts, OD’s, phasers, flangers, tremolos, wahs,
and all types of delay pedals. This amp was
designed to interface with all of your pedals
modern or vintage.
• Incredibly versatile single channel amp
• 50-watt 2X 6L6 Power Tubes
• 2x 12ax7s
• Solid State Rectifier
• Bass and Treble controls
• Master Level control
• Volume control
• Bright switch
• Bass emphasis switch
• Custom transformers and capacitors.
PLUGGING IN
We recommend that you start with the tone
controls in the 12 o’clock position. Set the Vol
level to about 11 o’clock and then increase the
Level control to the volume level you need.
The Volume and Level controls are interactive.
Your highest levels of clean will be with the
volume control below 3 o’clock. Above 3 o’clock
you are adding gain to the power section of the
amplifier.
Now that you have your gain and volume set
experiment with the bass , treble, bright switch
and bass emphasis switch.
We know you will love your new SW50. If you
have any questions or help don’t hesitate to email
us atinfo@morganamps.com or call Morgan
Amplification at 714 841 5302.
To Next Page
Loading...
