Operator Instruction Manual
FKS PrintBind KB 2000S
Perfect Binder for Cover-Binding and Padding
Update to Instruction Manual for model FKS PrintBind KB 2000
Model:FKSPrintBindKB2000S
Attention::
This instruction manual for modelFKSPrintBindKB2000Sis based oninstruction manual for modelFKSPrintBindKB2000and
the extrasheet of instruction for „set‐up of the nipping plates incoverstation“.
Theoutfit and operator instructions for modelFKSPrintBindKB2000S,thereafter named:„KB2000S“,are as follows:
Themain outfit and the upgraded efficiency are covered by:
1. TheKB2000Sis delivered factorywise mounted onstand‐cabinet
sturdy made outo
metal.
2. Thecompressor for air pressure is included and already installed inside the stand‐cabinet.
Allwiring and tubes are connected.
3. Thenew advanced slitting tools present widerand deeper slitting for better glue penetration onspine
4. Slitting paper dust might occur and is exhausted into aseparatewaste‐bag
5. Thesurface of the 2glue drums is scored for upgrade the glue supply.This enables equal glue apply even onwide spines.
6. For better function and designthe topsafety covergot anew layout.
7. Sofar the cooling‐rack had been suppled for separatepositioning.For KB2000Sthe rack can be mounted left hand onstand ‐
8. For service engineers only:KB2000Sis equipped with a keylockswitch for running the machine whilst safety coveris open.
This function is allowed for authorized service only.
To Next Page
Loading...
