Morgana KB2000 - Page 36

FKS PrintBind KB 2000S
Zu 4:
Dust
Bag
Zu

4
.
:

Dust
Bag
Whilst permanentuse of the machine the dust‐bag mustbe controlled
and emptied regularly.Please checkmin.weekly!
Zu2.:Compressor for air pressure
Theair compressor is integrated and mounted complete inside the stand
cabinet factorywise.Detailed instructions please see instruction manual
for modelKB2000
Zu3.:Slitting device
Thetooles inthe slitting device produce awiderand deeper slitting of
the spine for better penetration of glue.Detailsfor set‐up of depth for
slitting please see instruction manual for KB2000
Zu5.:Glue Assembly – Glue Drums
Thesurface of the 2glue‐drums is scroed for more efficient and equal
glue supply to the spine.
Zu7.:Cooling Rack
Inthe by‐pack‐kit the cooling rack is supplied.This can be mounted left‐
hand side onthe standcabinet.Thescrews are fixed already intheaded
holes instandcabinet
Zu8.:Key‐Lock‐Switch
For service‐personalonly: Key‐Lock‐switch for test‐runs without
closed safety hood.Switch‐Keys are enclosed and remain with
authorized,regionalsupplier