MORLEY-IAS ZX2e - User Manual

ZX1e
ZX2e
Document No. 996-130 Issue 01
user
manual
ZX5e

Summary

Introduction and Safety Information

Warnings and Cautions

Procedures to avoid injury and damage to equipment, assuming user training and regulatory compliance.

User Control Levels and Access

User Level Definitions

Defines three user control levels: Level 1 (display only), Level 2 (operation parameters), and Level 3 (installer/maintenance).

Controls and System Displays

Level 1 Display and Control Operations

AC Mains Power Failure Handling

Details the indications (flashing AC Power LED, buzzer, 'AC Fail' message) and behavior during AC power loss or total power failure.

Fire Alarm Conditions and Response

Describes FIRE LEDs, Zone FIRE LEDs, buzzer, and alphanumeric display for fire alarms, including manual evacuation.

Level 2 User Functions and Operations

Power Failure Status and Actions

Explains AC Mains failure indications and actions, and Battery Low/Charger Failure messages and clearing procedures.

Fault Condition Management

Covers fault indications, user actions like acknowledging and silencing the buzzer, and resetting the panel after correction.

Fire Alarm Event Handling

Details fire alarm indications and user actions, including silencing buzzers, acknowledging, silencing sounders, and resetting the system.

System Testing Procedures

Enable;Disable System Functions

Level 3 Programmer Functions

Commissioning and Programming

MORLEY-IAS ZX2e Specifications

General

Power Supply	230V AC, 50Hz
Zones	2
Monitored inputs	2
Relay outputs	2
Interconnect	Yes