MORLEY M48 - M48 Saw Specifications and Features; M48 Watercooled Specifications; Optional Equipment; Lubrication and Service Chart

M48 SAW INFORMATION
1. ThisManualprovidesthebasicinstructionsfortheoperationandmaintenanceof
theM48concretesaw.AndEngineManualisalsoprovidewitheachsaw.
2. M48 - WATERCOOLED:
ENGINE: Hyundai ZPP 416 - Gas
Drive Unit: Hydrostatic Transmission
Water Pump: Self-priming Electric (Optional)
Spindle: 1-7/16”
Arbor Size: 1” with 1/4” Keys
Blade Capacity: 14” to 36” Diameter
Depth Control: Hydraulic Raise/Lower
Depth Gauge and Locking Stop
Fuel Capacity: 5-Gallons
Weight: Single Speed: 1,040 Lbs, 3-Speed: 1,130 Lbs
Length: 43”
Width: 29” w/Quick Detach Spindle
Height: 44”
OPTIONAL EQUIPMENT
1. 3-Speed Gearbox
2. Night Light
3. Bladeguards - 24”, 30”, and 36”
4. Electric Water Pump
3. Thenewmachinewastest-runbeforeleavingMorleyEquipmentCompany,
however,theengineshouldbecheckedwiththeEngineManualsothatthe
correctroutineisfollowedatalltimes.Checkallfluidlevels.Thisisvery
importantduringtheinitialrunning-inoftheengineasspecifiedintheEngine
Manual.
4. LUBRICATION/SERVICE CHART
ITEM
HydrostaticTransmission(F/R)
AirFilter
HydraulicPump(R/L)
SpindleBearings
PivotAxle
FrontWheels
Radiator
CHECK
Monthly
Weekly
Monthly
Daily
Weekly
Weekly
Daily
LUBRICANT
20W-50MotorOil
Serviceasrequired
ATF
Grease
Grease
Grease
Squirtdebrisoutof
coolingfins