MorphoAccess® SIGMA Series
Simplified Setup Reference
STEP 5 | CHOOSE ONE POWER SOURCE (NOT BOTH): EXTERNAL 12V OR POWER-OVER-
ETHERNET. MorphoAccess® SIGMA Series terminals will only accept power from either PoE or
an external power supply, but not both simultaneously, nor in tandem.
STEP 6 | POWER THE SIGMA TERMINAL
For External Power: 12-24 Volts (regulated) 1 Amp and must comply with CEE/EEC
EN60950 standard. External power could be provided by a 12-Volt Wiegand power
supply. Minimum: 12V @ 1A. Refer to Step 3.
For PoE (Power over Ethernet): Install the PoE Board. Then, connect the PoE cable to
the RJ45 jack into the back of the SIGMA series terminal. See the diagram below.
Power-over-Ethernet (PoE) Board
NOTE: Pay special attention to the orientation of the pins on the PoE Board
To Next Page
Loading...