MorphoAccess® SIGMA Series
Simplified Setup Reference
STEP 7 | CHANGE THE FIRST BOOT CONFIGURATION STORAGE TYPE TO PERMANENT THEN
REBOOT. Follow the step-by-step guide below:
NOTE: Do not skip this step. By default, the First Boot Configuration Storage Type is set to
Temporary. After setting the storage type to Permanent, the SIGMA terminal must reboot for
the changes to save.
7.1 | Press the DOWN ARROW to the First Boot Configuration Storage Type menu.
FIRST BOOT ASSISTANT will be the first menu to appear after powering the SIGMA
terminal.
To Next Page
Loading...