Morphy Richards AD29112 - Rev1 1;9;06 09:40; How to Connect the Speakers to Main Unit; Tips for Connecting the Speaker Wires; Speaker Terminals

33 44
UUKK HHeellpplliinnee
00887700 006600 22661144 IIrreellaanndd HHeellpplliinnee 11880000 440099111199
HOW TO CONNECT
THE SPEAKERS TO
MAIN UNIT
Tips for connecting
the speaker wires
Push and hold the speaker
terminal tab down to insert each
wire.
Release the tab to lock the wire
into the terminal, make sure the
wire is fully inserted, but the
insulation is not covering the
inserted part of the speaker
wires.
Speaker terminals
Terminals of unit
GO ON TO THE NEXT WIRE &
REPEAT ABOVE. REMEMBER
WIRES MUST GO FROM THE
SET TO THE SPEAKERS.MAKE
SURE POWERS IS OFF WHEN
DOING THE ABOVE.
NOTE: Be sure to match the
speaker wire to the appropriate
terminal on the components: (+)
to (+) (colour), and (-) to (-)
(black). If the wires are reserved,
the sound will be distorted and
will lack some tones. Follow the
colour of each speaker.
TERMINAL
TAB
Push down on each tab of terminal.
TERMINAL
TAB
While holding down the tab of the terminal,
Stick the exposed part of the wire into the
Hole of the terminal.
⁄
¤
‹
›
Remove your finger from the terminal to
Lock the wire inside the terminal
On the back of
the set , you will
need to push up
the colored
terminals and
down on the
black terminals.
29112 rev1 1/9/06 09:40 Page 4