Morphy Richards BRITA - Replacing the Filter Cartridge; BRITA Memo; Setting the BRITA Memo

5
• For maximum filter performance and for optimum
taste, it is important to change your BRITA
MAXTRA Filter Cartridge (9) regularly. BRITA
recommends that you replace the cartridge every
4 weeks.
The unique BRITA Memo
(11) measures the
recommended time of use of your cartridge. The
BRITA Memo is located on the filter kettle handle.
Setting the BRITA Memo
• To start BRITA Memo, please press and hold
down the Start Button (12) until all four bars
appear in the display and flash twice. The BRITA
Memo is now set.
• The Cartridge Active Indicator Light (14) in the
bottom right corner of the BRITA Memo indicates
that it is working.
• Every week, one bar will disappear on the
Cartridge Life Gauge (13) to show the remaining
cartridge life. After four weeks, all four bars will
disappear and a flashing arrow will indicate that
the cartridge should now be changed. Insert a
new cartridge according to the instructions, and
reactivate the Memo by following ‘Setting the
BRITA Memo’.
BRITA Memo
4
Your Filter Cartridge is ready for use.
3
x2
Fill the kettle to the MAX line as normal and
allow to filter through completely to flush the
cartridge. Repeat twice
2
Push the Filter Cartridge into the BRITA
Hopper (10) until firmly in place. The Filter
Cartridge should stay in place if the kettle is
upside down.
Replacing the filter cartridge
1
Immerse the BRITA MAXTRA Filter Cartridge
(9) in water. Shake gently to remove any air
bubbles.
after 4 weeksfull
43960 rev3_Layout 1 21/10/2013 09:56 Page 5