Morphy Richards VECTOR - Using the Strength Selector; Pre-setting a Brewing Time

6
• Switch off your coffee maker and allow 3 minutes
to cool before refilling with cold water.
Refilling Your Coffee Maker
4
After setting is complete, the machine will
beep and display the selected time for 3
seconds before switching back to the current
time. To cancel this program, press the
Program/Clock Button
(11) again so the
‘PROGRAM’ icon disappears.
3
The default time will show 12am. Use the Up
(14) and Down (15) buttons to change the
time and press Program
(11) to confirm.
2
Press the Program/Clock Button (11), the
Screen will display ‘PROGRAM’.
To Pre-set a Brewing Time
1
Follow ‘Using your coffee maker - Quick Start’
steps 1-3 on page 5.
Ensure the clock is set before attempting to pre-set the brewing time.
Follow the ‘Setting the clock’ instructions on page 5.
• Y
ou can adjust the brew strength for any volume
o
f coffee (from 1 cup to a full 12 cup carafe). To
do this, follow the steps below:
1
Press the Strength Selector Button (12) once,
the display screen will flash STRENGTH
a
nd show icon.
2
To choose between strengths, use the Select Up
a
nd Down
(
14 & 15)
B
uttons.
3
Press the Strength Selector Button (12) to
confirm.
• H
owever, if you are brewing 1-4 cups, the
m
achine can automatically set the optimum
program for you. This is specially adapted for
s
mall quantities. Follow the instructions below:
• For brewing 1-4 cups of coffee, press and hold
t
he Strength Selector Button
(
12)
f
or 3 seconds.
The screen will display . The machine will
a
utomatically adjust the cycle.
Using the Strength Selector
CM163002 MUK REV1.qxp_Layout 1 22/08/2017 10:32 Page 6