MORryde SRE4000 - User Manual

To Next Page

SRE4000 TANDEM w/ CROSS MEMBER

INSTALLATION INSTRUCTIONS

The MORryde X-Factor crossmember kit is designed to provide added strength and reinforcement to trailer frames.

The crossmember can be installed onto a single spring hanger or for added strength and reinforcement onto all of

the spring hangers on the frame. The installation instructions for the kit and the SRE4000 are detailed below.

WARNING

The SRE4000 suspension system warranty is void if crossmember is not installed.

574.293.1581 • MORryde.com

TOOLS REQUIRED:

• Torque Wrench

• 11/16" Socket & 13/16" Wrench

• 9/16" Socket & Wrench

• 1/2" Socket & Wrench

• Floor Jacks

• Safety Stands

• Ratchet

• Alternate Tools for Reinforced

Frame Hanger: 5/16" Drill Bit & Drill

PARTS LIST:

• Crossmember Half w/ Holes, 2nd Half w/ Slots

• (2) SRE4000 Equalizers

• (2) Clamp Strap

• (8) 3/8-16 x 1 Flange Bolt

• (8) 3/8-16 Flange Locknut

• (4) 5/16-18 x 1 1/2 HHCS

• (4) 5/16-18 Locknut

• (2) 7/16-20 x 3.40 Wet Bolt

• (2) 7/16-20 Flange Locknut Shoulder Bolt

Need help?

Do you have a question about the MORryde SRE4000 and is the answer not in the manual?

Summary

Introduces the SRE4000 crossmember kit, states warranty voidance, and lists necessary tools and parts.

Comprehensive, sequential guide for mounting the SRE4000 crossmember onto a standard 3-inch wide trailer frame hanger.

General