MORryde STABILIZER - ADDITIONAL TROUBLESHOOTING; Motor Running Rough; Leg Does Not Retract Fully; Leg Will Not Move

To Previous Page

574.293.1581

MORryde.com

TROUBLESHOOTING CONTINUED

MORryde STABILIZER

OWNER’S MANUAL

Solution: Check if the switches stick in either the extend or retract

positions. If so, the switches, breaker (type two or three 15 amp), and

motor need to be replaced.

Problem: The motor is burnt.

Solution: Check if the motor is receiving power. If yes, check if the

motor is burnt. Is the plastic housing melted or does the motor smell

burnt? If yes, contact the OEM to replace the motor. If the motor runs

but the leg does not operate, check if the coupler that connects the

motor to the worm gear is missing or broken.

Problem: The leg will not move at all.

Solution: Check if the leg is bent. If yes — replace the leg. If the leg is

NOT bent, then check for debris on the worm gear and also grease the

worm gear. If no debris is present and grease does not help, replace

the motor.

Solution: Check if the leg is bent. If yes — replace the leg. If the leg is

not bent, then check the motor operation.

Problem: The motor is running rough.

Problem: The leg does not retract

all the way.