7. Place 3-4 pieces of fuel weighing roughly
4-6 lb. across the embers in one layer, with
spacing of roughly 1 inch between the
pieces of wood.
8. When the primary air supply (upper
controler) is open all the way and the door
is closed, the new fuel will ignite in a few
minutes
5. After 5-10 minutes the chimney draft
should be established, at this point close
the fire door. If all the necessary conditions
are met, a nice layer of embers will start to
accumulate after another 15-20 minutes.
6. Refuelling of your stove should be done
while there are still glowing embers in the
bed. Spread the embers across the bottom,
but concentrated mostly towards the front
of the stove
3. Fully open the upper air controler so
that the primary air supply can enter the
firebox
4. After the paper/fire lighters have
caught fire, leave the fire door ajar about
1 inch, so that the chimney draws well
To Next Page
Loading...
