11
Installation Instructions
Air kit set Morsø 3112/3142/3600/7110
Kit Contens:
(1) Air duct adaptor
(2) 3,5 X 6,5 mm sheet metal screws
Installation:
1. Place adaptor flange against the shield aligning the three pre-drilled holes of
the flange to the holes on the shield.
2. Install the three sheet metal screws securing the flange to the shield.
3. Installation is now complete. You may now connect your air duct to the stove.
Floor to center of the air collar:
Morsø 3600: 322 mm (12,7 inch)
Morsø 7100 - 206 mm legs: 324,5 mm (12,8 inch)
Morsø 7100 - 276 mm legs: 394,5 mm (15,5 inch)
Morsø 3112: 317 mm (12,5 inch)
Morsø 3142: 368 mm (14,5 inch)
If you have any further questions, please contact your authorized Morsø dealer.
MORSØ JERNSTØBERI A/S . DK-7900 NYKØBING MORS
E-Mail: stoves@morsoe.com · Website: www.morsoe.com
To Next Page
Need help?
General
