18
19
DK ENG
Clean the chimney connector disconnecting the sections, taking them outside, and remov-
ing any deposits with a sti wire brush. Reinstall the connector sections after cleaning, be-
ing sure to secure the joints between individual sections with sheet metal screws.
If you cannot inspect or clean the chimney yourself, contact your local Morsø Dealer or a
professional chimney sweep.
If you do experience a chimney re, act promptly and:
1. Close the air control.
2. Get everyone out of the house.
3. Call the Fire Department.
Annual maintenance
Before the heating season, perform a thorough cleaning, inspection and repair:
Thoroughly clean the chimney and chimney connector.
Inspect the chimney for damage and deterioration. Replace weak sections of prefabricated
chimney. Have a mason make repairs to a masonry chimney.
Inspect the chimney connector and replace any damaged sections.
Check gasketing for wear or compression, and replace if necessary.
Check the glass for cracking; replace if needed.
Check door and handle for tightness. Adjust if needed.
How to clean the inside parts of Morsø 6100
When cleaning the inside parts of the stove in connection with the annual visits from your
local chimney sweep we recommend that you remove the inside parts from the re cham-
ber. Please be careful as the vermiculite parts are porous. Cleaning of the stove must be
done when the stove is cold.
ALWAYS USE ORIGINAL MORSØ SPAREPARTS
1. The bottom bae is lifted up a bit and held in that posi-
tion. Loosen the side bricks.
2. Tip the side bricks and remove them from the re chamber.
3. Tip the other side brick and remove it from the re
chamber.
4 When the side bricks are removed the bottom bae is
lowered and lifted out of the re chamber.
5. The upper bae is removed from the brackets and lift-
ed out of the rechamber.
To Next Page
Loading...
