5. Re-stoking should normally be carried out while embers
still remain. Distribute the embers in the bottom, ensuring
that most of them are at the front of the stove.
6. Place 2 pieces of wood of approx. 0.7 kg each and approx.
25-30 cm long over the embers in a single layer, with a di-
stance of approx. 1 cm.
7. Open the air supply to maximum and close the door; the
fresh wood will then ignite within a couple of minutes.
8. Reduce the amount of combustion air to the desired position,
and optimal combustion will continue until there are glow-
ing embers in the bed.
During the nominal test, the stoking interval was 60-70 mi-
nutes.
9. A new portion of wood can be added by repeating steps
5 & 6.
To Next Page
Loading...
