Why will my Mosaic SRPH32 burner not light?
If the burner on your Mosaic Patio Heater won't light, first, make sure the gas cylinder valve is turned ON. If the pressure is low, turn the gas cylinder valve OFF and replace the gas cylinder. If these steps don't resolve the issue, it's possible that the hose and regulator are broken, or the valve is broken, requiring you to call customer service.
What to do if the flame keeps extinguishing on my Mosaic SRPH32?
If the flame on your Mosaic Patio Heater keeps extinguishing, it might be due to dirt built up around the tip of the thermocouple; clean the dirt from the thermocouple. Alternatively, the connection between the thermocouple and valve may be loose; tighten this connection. If neither of these solutions works, the tilt switch or valve may be broken, and you should call customer service.
How to fix a Mosaic SRPH32 that lights manually but not with the knob?
If your Mosaic Patio Heater burner can be lit manually but not with the control knob, check the connection between the valve and ignition pin and tighten it if it's loose. Also, adjust the distance between the ignition pin and flame orifice if it's incorrect. If the issue persists, the ignition pin may have failed, and you should call customer service.
Guidelines for installing the heater with partial or full shelter.
Lists tools that are not included with the patio heater.
Procedure for checking gas connections for leaks using a soapy solution.
Procedure for annual safety inspection of the heater components.
Pre-operation checks and safety precautions before turning on the gas supply.
Inspection and safety checks to perform before lighting the heater.
Instructions for storing the heater between uses and during extended inactivity.
General| Brand | Mosaic |
|---|---|
| Model | SRPH32 Series |
| Category | Patio Heater |
| Language | English |
To Next Page
