What to do if my Moso Inverter shows a Grid Fault?
If your Moso Inverter displays a Grid Fault, first wait one minute to see if the grid returns to normal. Ensure that your grid voltage and frequency meet the required standards. Check the grid connection, including wiring and interfaces, and confirm the grid's usability. If the issue persists, consider switching off to grid.
What to do if I see a DCINJ High error on my Moso Inverter?
If you encounter a DCINJ High fault with your Moso Inverter, try disconnecting and then reconnecting the PV (+) and PV (-) with the DC input. Also, inspect the L and N lines for any connection faults.
Why is my Moso SF4.2KTN showing a PV Over Voltage error?
If you are experiencing a PV Over Voltage issue with your Moso Inverter, check the panel’s open-circuit voltage to see if it is close to or exceeds the maximum DC voltage.
How to fix a Relay Fault on a Moso SF4.2KTN Inverter?
If your Moso Inverter is showing a Relay Fault, disconnect the PV (+) and PV (-) from the DC input, then reconnect them.
What to do if my Moso Inverter SF3.6KTN,SF4.2KTN,SF4.6KTN,SF5KTN has a Self Testing Fault?
If your SF3.6KTN, SF4.2KTN, SF4.6KTN, or SF5KTN Moso Inverter displays a Self Testing Fault, verify that it is operating in IN1 & IN2 P mode. Also, check PV1 and PV2 to ensure they are properly connected.
General| Category | Inverter |
|---|---|
| Output Power | 4200W |
| Input Voltage | 24VDC |
| Output Voltage | 220VAC |
| Frequency | 50Hz/60Hz |
| Model | SF4.2KTN |
| Protection | Overload, Short circuit, Over Voltage, Low Voltage, Over Temperature |
| Cooling | Fan |
| Operating Temperature | -10°C to +50°C |
To Next Page