11
For Warranty Service Call: 833-474-0367 Range Owner’s Manual 20201109
Recommended Cleaning of the Griddle
• DO NOT use any abrasive or flammable cleaning fluids.
• DO NOT hose down, immerse, or pressure wash any part of the Griddle, excluding the catch tray.
NEVER use a scrubber pad (on all exterior surfaces, except the griddle plate), steel wool or abrasive material,
or cleaners containing chlorine, iodine and ammonia, or bromine chemicals as these will deteriorate the
stainless steel and shorten the life of the unit.
It takes very little time and effort to keep the Griddle attractive and performing at top efficiency. Wait until the
griddle is cool after the unit had been turned off. Please follow the cleaning steps below:
Use a clean cloth and a non-abrasive cleaner to clean the stainless steel
body of the Griddle. Wipe the polished areas with a soft cloth.
Thoroughly clean. Wipe with clean, warm mild soapy water then re-wipe
splashes with a damp cloth.
Unit should be turned off when not in use.
It is recommended that the unit be disconnected from the gas supply by
closing the main gas valve. Use a clean cloth to wipe any grease or debris
from the control knobs.
Clean surface with a grill pad or metal spatula, being careful not to scratch
the griddle surface.
• Clean the griddle surface thoroughly. If necessary, use a griddle
stone or grill pad. (If a griddle stone is not used correctly it will
damage the Griddle surface).
• Rub with the grain of the metal while the griddle is still warm. A mild
soap may be used on the plate surface to help clean it.
• The plate should then be covered with a thin film of oil to prevent
rusting.
• Clean stainless surfaces with a damp cloth and polish with a soft
dry cloth. To remove discoloration, use a nonabrasive cleaner.
• After each “weekly” cleaning with mild soap and water, the griddle
must be seasoned again. If the griddle usage is very high, the
“weekly” cleaning procedures may be done more often than once a
week. *The use of ice on the griddle plate to cool may damage the
plate.
Once the unit has cooled, remove the catch tray and discard the waste,
grease, debris and crumbs.
CAUTION: If the catch tray is permitted to fill too high, grease/debris is
likely to accumulate under the unit.
This catch tray/drawer is removed by pulling forward.
USE CAUTION WHEN REMOVING!
To Next Page
Loading...
Need help?
General
