CONNECT DOWN
M
E
M
O
R
Y
Connect RF Adapter to control box
Connect RF Adapter to control box (or Twinmat) by inserting the plug of
RF Adapter to the handset socket on the control box. the green LED on
the RF Adapter will light on for around 1 second to show that connection
is done.
Lock Mode
Press the red lock button on the rear side of the remote handset to lock
the buttons on the front side. The orange LED on the front side will flash
4 times to show that buttons are locked. To unlock, simply press the red
lock button one more time, 4 flashes of the green LED will follow to
show that it's now in unlock mode. Please press the lock button to
unlock, whenever the batteries are changed.
Pair with Remote Handset
Put the plug of RF Adapter into the handset socket of the control box (
the LED will be on for 1 second), press and hold "connect" button on the
RF Adapter until the LED flashes (around 2 minutes), release the
"connect" button on the RF Adapter and press any button on the
Remote handset to pair the remote handset and the RF Adapter.
*This step is necessary when remote handset is NOT controlling the RF Adapter or
a new remote handset is used.
Clear Remote Handset
Plug out RF Adapter, press and hold "connect" button, then plug RF Adapter in the
socket of the control box, while keep holding the "connect" button (around 5 seconds)
until the LED turns off.
Caution:
This device might be interfered by some other devices with same frequency (2.4 GHz;
eg. WIFI router or WIFI hub). If so, please move any port of the dip switch in the battery
room to change channel and pair the remote handset with the TX adapter one more
time.
Emergency Lowering
Press "down" button on the RF Adapter to lower down ALL the actuators
or motors.
Green LED
Orange LED
Lock Button
User Guide
TXH5 Handset
Model: TXH5
MOTORIZE OUR WORLD
R
To Next Page
Need help?
General