7
6. Turn on the brewer and allow the water to run through a brew cycle.
7. Let the brewer cool down for 5 minutes before repeating the process at
least 2 more times before brewing coffee.
Brewing Instructions:
1. Swivel filter basket to right and remove it from the holder.
2. Remove the detachable water reservoir by holding the recessed grip
and pulling straight up.
3. Remove the water reservoir lid and fill with the required volume of
fresh, filtered, cold water to the desired batch size. Do not fill above the
MAX line. (Fig.1)
4. Close the water reservoir by replacing the lid and insert it back into the
appliance. Please ensure that you replace the reservoir upright into the
appliance. The guide rails on the appliance (left of the reservoir) will
help you with this.
5. Fold over the seamed edges of a # 4 paper filter and place in the filter
basket. Scoop the ground coffee into the paper filter. (Fig.2)
6. Put the filter basket back into its holder. First hang the eyelet of the filter
on top of the swivel arm. Next, press the round base into the clip. An
audible click tells you it is inserted properly.
7. Swivel the filter basket to left to lock in place. Place the stainless steel
thermal carafe with lid attached onto carafe plate. (Fig.3)
8. Set 24 hour clock to correct time by pressing the H (hour) and M
(minute) buttons.
9. Press the ON/OFF button. The ON/Off button will illuminate in green
indicating the machine is operating. (Fig.4)
10. When the audible alarm sounds the brew process is complete.
Sometimes the filter basket may need a few more seconds to fully drain
before removing carafe.
11. To pour coffee from the carafe, depress the lever on the carafe lid.
To Next Page
Loading...
