17
4. Oil filling procedure
Level the engine.
Remove the oil fill cap and add fresh oil. First add 1.7 liter.
Start and run the engine on idle for 30 seconds.
Shut engine off and wait 30 seconds.
Add more oil slowly to bring the level to Full mark on dipstick.
Do not overfill.
Replace the oil fill cap and dipstick.
II. Spark plug exchange procedure
1. Disconnect the battery, take off spark plug wire and clean the space around spark plug to
avoid any debris get inside combustion chamber.
2. Unscrew the spark plug using spark plug spanner, and clean spark plug holes.
3. Screw in new sparkplug by hand until the gasket reaches the cylinder head.
4. Tighten with touque 25-30Nm.
To Next Page
Loading...