eng i

FCC and IC Compliance Statement

PINPOINT KEY FOB, FCC ID ‑ MVU10148

ACMA: N2523

IC: 6094A‑09291, 6094A‑09305

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received including interference

that may cause undesired operation.

This device complies with FCC Rules. Changes or modifications not expressly

approved by MotorGuide could void the user's authority to operate the

equipment.

The MotorGuide Pinpoint GPS System complies with Industry Canada RSS‑210

standard. See RSS‑GEN 7.1.5. The term "IC:" before the certification/

registration number only signifies that registration was performed based on a

Declaration of Conformity indicating that Industry Canada technical

specifications were met. The term "IC:" before the certification/registration

number does not imply that Industry Canada approved the equipment.

EU Compliance Statement

Attwood Corporation hereby declares that the Motorguide Pinpoint GPS System

is in compliance with the essential requirements and other relevant provisions of

the 99/5/EC R&TTE directive.

A copy of the original CE Declaration of Conformity is on our website at http://

www.motorguide.com/support/certifications.

Environmental Compliance Statement

All MotorGuide products that are subject to the 2002/96/EC WEEE directive are

compliant with the WEEE marking requirement. Such products are marked with

the "crossed‑out wheelie bin" WEEE symbol (shown, below) in accordance with

European Standard EN50419.

54539

Pinpoint GPS 90-8M0086988 1213

MotorGuide Pinpoint - Setup Instructions Manual

Other manuals for MotorGuide Pinpoint