6
English
Note:
• You will see the icon blinking on the display. This
confirms that the radio is in Easy Pairing mode waiting
to receive the Channel and Sub-Code settings from
the Leader’s radio. All Members’ radios will remain in
this mode for 3 minutes.
• A group with many radios should have all users take
this step at the same time, so all radios can be
programmed in one go.
3. On the Leader’s radio, press and hold down the button
until you hear a double beep.
Note:
• At the double beep, this radio’s Channel and Sub-Code settings
will be transmitted, which will be received and copied by all the
other (Members’) radios.
• The Leader’s radio must make this transmission when all the
Members’ radios are still in the Easy Pairing mode, otherwise the
transmission will not be picked up.
• On the Leader’s radio, user must remember not to release the
button on the first (single) beep, otherwise this radio will become
another Member’s radio. If that happens, you can press PTT to
escape, and retry the steps described in #3 again.
Internal Voice Operated Transmission/
Voice Operated Transmission ( / )
Transmission is initiated by speaking into the microphone of
the radio/audio accessory instead of pushing the PTT button.
1. Press Menu/Lock until the icon appears on the
display. When audio accessory is connected, the
icon will be shown. The current setting (Off, L1–L3) will
flash.
2. Press or to select the sensitivity level.
3. Press the PTT button to exit menu or Menu/Lock to
continue set up.
Note: When using iVOX/VOX, there will be a short delay.
Dual Channel Monitor
Enables you to scan the current channel and another
channel alternately.
To set another channel and start Dual Channel Monitor:
1. Press Menu/Lock until the Dual Channel Monitor
icon appears. The Dual Channel Monitor icon will flash.
2. Press or to select the channel then press Menu.
3. Press or to select the Sub-Code.
4. Press the PTT button or wait until time out to activate
Dual Channel Monitor. The screen will alternate between
home channel and Dual Channel Monitor channel.
5. To end Dual Channel Monitor, press Menu/Lock.
Note: If you set the same channel and Sub-Code as the
current channel, Dual Channel Monitor does not work.
L3 = High Sensitivity for quiet environments
L2 = Medium Sensitivity for most environments
L1 = Low Sensitivity for noisy environments
MN004538A02.book Page 6 Saturday, July 24, 2021 6:14 PM
To Next Page
Loading...
Need help?
General