EasyManuals Logo

Motorola solutions T62 User Manual

Motorola solutions T62
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
3
English
Installing the Batteries
Each radio can either use a NiMH rechargeable battery pack
or three units of AA Alkaline Battery, and beeps when the
batteries are low.
1. Make sure your radio is turned off.
2. To remove the battery compartment door, press the tab
at the bottom of the compartment door.
3. For NiMH battery pack, insert the battery pack with the
and signs facing you. Observe polarity.
For AA Alkaline batteries, insert the batteries. Observe
polarity.
4. Close the battery compartment door.
Low Battery Alert: When the battery is low, the radio
produces an audio alert periodically and after each PTT
transmission.
Battery Capacity Maintenance
1. Charge the NiMH batteries once every three months
when not in use.
2. For storage purposes, remove the battery from the radio.
3. Store the NiMH batteries in a temperature between
-20 °C to 35 °C and in low humidity. Avoid damp
conditions and corrosive materials.
Using the Micro-USB Charger
The micro-USB charger allows you to charge your NiMH
battery pack.
1. Power off your radio before start charging.
2. Plug the micro-USB cable into the micro-USB charging
port on your radio.
3. Connect the USB charger to a nearby and easily
accessible wall power outlet.
4. An empty battery will be fully charged in 8 hours.
5. The battery meter bar will scroll when the battery is
charging.
Note: When moving between hot and cold temperatures, do
not charge the NiMH battery pack until the temperature
acclimates (usually about 20 minutes).
For optimal battery life, remove the radio from the
charger within 16 hours. Do not store the radio while
connected to the charger.
Turning your Radio On and Off
Press and hold the Power button to turn the radio on or off.
1. In the on position, the radio chirps and briefly shows all
feature icons available on the radio.
2. The display screen then shows the current channel,
code, and all features that are enabled.
Setting the Volume
From Standby Mode, press on either or to show the
current value. Press or again to adjust the volume
setting.
1. Press to increase the speaker volume.
2. Press to decrease the speaker volume.
Do not hold the radio close to your ear. If the volume is set to
an uncomfortable level, it could hurt your ear. Adjust ‘0’ to
mute the speaker.
MN004538A02.book Page 3 Saturday, July 24, 2021 6:14 PM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Motorola solutions T62 and is the answer not in the manual?

Motorola solutions T62 Specifications

General IconGeneral
BrandMotorola solutions
ModelT62
CategoryTransceiver
LanguageEnglish