Depending on how your radio is programmed, if there is no answer after the maximum ring time or
when you press the PTT button for an Enhanced Private Call, the radio automatically sends a call alert
page.
NOTE: This feature must be programmed by a qualified radio technician.
7.6.1
Receiving a Call Alert Page
When and where to use: When you receive a Call Alert page, you hear four repeating alert tones and
the LED blinks green. The call received icons blinks and the display shows PAGE RCV.
Procedure:
Press any button to clear the Call Alert page.
7.6.2
Sending a Call Alert Page
When and where to use:
Your radio must be preprogrammed for you to use this feature.
Procedure:
• Press the preprogrammed Call Alert Paging button to send a page to the preprogrammed ID.
If the call alert page is sent successfully, a tone sounds and the display shows the current zone
and channel name.
If the call alert page is not acknowledged, a tone sounds and the display shows the current zone
and channel name.
7.7
Recent Calls
Recent call menu allows you to view the recent incoming and outgoing call information.
You can view the information of the following type of calls:
• Call Alert
• Selective Call
• Private Call
• Phone Call (Outgoing Only)
• Emergency Call (Incoming Only)
NOTE: The Log Dispatch Calls Enable field need to be enabled in Customer Programming
Software (CPS) for your radio to log the dispatch call.
7.7.1
Instant Recall
This feature allows you to save and play back the recent received calls. All saved calls are removed
upon radio power cycle.
68012003047-HW
Chapter 7 : Advanced Features
46
To Next Page
Loading...
