Advanced Features
English
35
In addition, each alarm has the following types:
• Regular – Radio transmits an alarm signal and shows audio
and/or visual indicators.
• Silent – Radio transmits an alarm signal without any audio or
visual indicators. Radio receives calls without any sound
through the radio’s speaker, until you press the PTT button to
initiate the call.
• Silent with Voice – Radio transmits an alarm signal without
any audio or visual indicators, but allow incoming calls to
sound through the radio’s speaker.
Only one of the Emergency Alarms above can be assigned to
the programmed Emergency button.
Receiving an Emergency Alarm
When your radio receives an Emergency Alarm, a tone sounds
and the LED blinks red until you exit the Emergency mode.
Perform one of the following actions to silence the tone:
• Press the PTT button to call the group of radios which
received the Emergency Alarm.
• Press any programmable button.
• Exit Emergency mode.
NOTE: Your radio automatically acknowledges the Emergency
Alarm (if enabled).
Exiting Emergency Mode After Receiving the
Emergency Alarm
Exit the Emergency mode by performing one of the following
actions:
• Change the channel.
• Press the Emergency Off button.
• Power down the radio.
Sending an Emergency Alarm
This feature allows you to send an Emergency Alarm, a
non-voice signal, which triggers an alert indication on a group of
radios.
Procedure:
1 Press the programmed Emergency On button.
2 The LED lights up solid green. The Emergency Search Tone
sounds. It is temporarily muted when the radio transmits or
receives voice. The tone stops when the radio exits
Emergency mode.
NOTE: The Emergency Search Tone is an optional feature, it
can be enabled or disabled via the CPS programming
software. This feature is disabled, if Silent Emergency
is enabled. The CPS can also program tone to sound
to through the speaker of the radio (default) or wired
accessory. Check with your dealer or system
To Next Page
Loading...
Need help?
General
