Advanced Features
English
35
Finding and Connecting to a Bluetooth Device
Procedure:
Turn on your Bluetooth-enabled device and place it in pairing
mode. Refer to respective Bluetooth-enabled device’s user
manual.
1 On your radio, press the programmed Bluetooth Connect
button.
2 A tone sounds and LED blinks yellow.
3 Your Bluetooth-enabled device may require additional steps
to complete the pairing. Refer to respective Bluetooth-
enabled device’s user manual.
4 If successful, a positive tone sounds.
OR
If unsuccessful, a negative indicator tone sounds.
Do not turn off your Bluetooth-enabled device during the finding
and connecting operation as this cancels the operation.
Your radio connects to the Bluetooth-enabled device within
range with either the strongest signal strength, or to one which it
has connected to before in a prior session.
NOTE: A pin code may be required to be programmed in your
radio before it can pair with some devices. Contact
your dealer for more information.
Disconnecting from a Bluetooth Device
Procedure:
1 Press the programmed Bluetooth Disconnect button.
2 A positive indicator tone sounds when disconnected.
Switching Audio Route
You can toggle audio routing between internal radio speaker
and external Bluetooth-enabled accessory.
Procedure:
1 Press the programmed Bluetooth Audio Switch button.
2 A tone sounds when the audio route has switched.
NKP_EMEA.book Page 35 Monday, July 2, 2012 3:50 PM
To Next Page
Loading...