SCANNING
There are three types of scan available in the HT1250 radios. System
Scan can be st arted or stopped by pressing the preprogrammed
feature button.
System Scan can also be implemented using the Menu.
To select System Scan from the menu, do the following:
1. Press the Menu/Select key to enter the Menu mode.
2. Press the Up or Down Arrow until System Scan is shown in the
display.
3. Press the Menu/Select key to select the System Scan mode.
4. Press the Up or Down Arrow until Sys Scan On? is shown in the
display.
5. Press the Menu/Select key to confirm your selection.
6. To exit the System Scan function. Press the Up or Down Arrow
until
Sys Scan Off? Is shown in the display.
7. Press the Menu/Select key to confirm your selection.
HT 1250 Hot Zone Radio
To Next Page
Loading...
