165
Using GPS with Map Software
Getting Started
To connect your phone to your laptop or other
device with a data cable:
1 Open the connector cover.
2 With the phone’s display facing up, insert the
serial data cable’s connector into the accessory
connector, until you hear a click.
3 Insert the data plug into the COM port of your
laptop or other device.
Make sure no other application is using the COM
port selected.
Make sure the COM port settings of your laptop or
other device are set to the following:
• Bits per second: 4800
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: Hardware
connector
cover
To Next Page
Loading...
