Motorola iDEN i580 - Assigning a Ring Tone or Picture

41
Creating Entries
3 If you want to assign a ring tone or picture to the
entry, select [Ring Tone/Picture]. See
“Assigning a Ring Tone or Picture”.
4 To assign a Contacts type to the number or
address being stored:
Select the Contacts type field.
Select the Contacts type you want to assign.
Note: For information about creating SDG lists,
see “Creating SDG Lists in Contacts” on
page 61.
5 To store a number or address:
Select the # field (or ID for an email address, or
IP for an IP address).
Enter the number or address. For phone
numbers, use the 10-digit format. For email
addresses, see “Entering Text” on page 71.
Tip: Press A under Browse to select a number
or address from Contacts, the recent calls
list, or Memo.
When you are finished, press O.
6 If you want to change the default Speed Dial
number or a create a voice name for the entry,
select [Options]. See “Assigning a Speed Dial
Number or Voice Name” on page 42.
7 If you want to add more numbers or addresses
to the entry:
Scroll past the information you already entered.
Enter the additional information for the entry
using step 3 through step 6. You must assign a
name to the entry, if you have not already.
8 Press A under Save.
Assigning a Ring Tone or Picture
1 If you have not already, select [Ring
Tone/Picture].
2 If you want to assign a ring tone:
With Ringer highlighted, scroll left or right to
choose a ring tone from the list of ring tones.
-or-
Select Ringer. Select the ring tone you want to
assign from the ring tones available in the media
center.
3 If you want to assign a picture from the media
center:
Select Picture. Select the picture you want to
assign.
Some large pictures cannot be assigned.