9
Getting started
Connecting the handset and charger
(for multi-pack only)
If you have purchased a multiple pack, you will need to carry out this process for
all the handsets and chargers.
1. Plug the power adaptor into the socket marked on the underside of the
charger and plug the other end into the mains power wall socket.
2. Remove the battery cover from the back of the handset and insert the 2 x
rechargeable Ni-MH battery cells supplied. Please note the ’+’ and ’-’ markings
inside the battery compartment and insert in the
correct direction.
3. Slide the battery cover back into place.
4. If you are charging the batteries for the first time, place the handset on the
charger to charge for at least 16 hours continuously.
5. When the handset is fully charged, will appear steady on the display. The
display will show
HANDSET
and handset number (e.g. 2) to indicate that it is
registered to the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH
750mA rechargeable batteries) supplied with your IT.5XI.
BATTERY LOW WARNING
If is displayed on the screen, you must charge the handset before use it again.
When charging, will scroll on the display.
To Next Page
Loading...
Need help?
General
