How to eject a CD from my Motorola Laptop when it won't eject normally?
If you cannot eject a CD from your Motorola Laptop, manually release it: 1. Turn off the computer. 2. Insert a small rod, like a straightened paperclip, into the drive’s manual eject hole and push firmly. 3. Pull the tray out until fully extended, and then remove the CD.
How to fix a Motorola L3391 that is not charging?
If your Motorola Laptop battery isn't charging and the Battery Charge LED indicator isn't lit, try the following: * Ensure the AC adapter is properly connected. * Make sure the battery isn't too hot (above 55°C) or too cold (below 0°C). Allow it to return to room temperature. * Confirm the battery pack is correctly installed. * Check that the battery terminals are clean.
Why does my external monitor display nothing when connected to my Motorola L3391 Laptop?
If your external monitor displays nothing when connected to your Motorola Laptop, consider the following: * Ensure the monitor is turned on. * Verify the monitor's signal cable is properly connected. * Check the 'Display Mode' setting in the SCU program. * Switch the display to the monitor by pressing Fn+F9 or through Windows' Display properties.
What to do if my Motorola L3391 doesn't recognize a newly installed device?
If your Motorola Laptop doesn't recognize a newly installed device: * Check the device configuration in the SCU program. * Verify if a device driver installation is required. * Check if any jumper or switch settings are needed. * Inspect the cables or power cords for correct connections. * If it's an external device with its own power switch, ensure it's turned on.
How to troubleshoot a Motorola Laptop when the printer doesn't work?
If your printer isn't working with your Motorola Laptop, check these: * Ensure the printer is turned on and online. * Verify the printer's signal cable is properly connected. * Confirm the printer driver is correctly installed. * Check the assigned printer port in your operating system or application. * Ensure the printer port is enabled in the SCU program.
How do I enable the numeric keypad on my Motorola L3391?
To enable the numeric keypad on your Motorola Laptop, make sure that Num. Lk is switched on. Check if the Num. Lk LED Indicator lights green.
How do I adjust the resolution on my Motorola L3391 Laptop to the desired setting?
To adjust the resolution on your Motorola Laptop: * Make sure that the video driver is installed correctly. * Make sure that the video memory in the SCU program is configured properly. * If using an external display device, make sure that the device supports the desired resolution.
Why doesn't my Motorola L3391 automatically enter Standby or Suspend mode?
Your Motorola Laptop might not automatically enter Standby or Suspend mode if you have an active connection to another computer or if the Standby or Suspend time-out is not enabled. Check these settings to resolve the issue.
Why is my external keyboard not working with my Motorola Laptop?
If your external keyboard isn't working with your Motorola Laptop, ensure that the keyboard cable is properly connected.
What does it mean when a hard disk drive error message appears on my Motorola L3391 Laptop screen?
If a hard disk drive error message appears on your Motorola Laptop screen: * Insert a bootable diskette and check the integrity of your hard drive. * It could indicate defects in the hard disk drive, so it is advised to seek assistance from your dealer.
Steps for unpacking, connecting power, opening/closing, and powering on/off.
Covers startup, keyboard, touchpad, and touchscreen usage.
Charging, initializing, checking, and replacing the battery pack.
Explanation of standby, hibernation, and power management features.
Reasons for running SCU and steps to access BIOS setup.
Details on setting date/time, numlock, USB emulation, and boot sequence.
Categorized solutions for common hardware and software issues.
To Next Page
General