Getting started 7
Connecting the base
1.
Plug the power adapter with smaller pin plug &
telephone line cord into the base. Power adapter with
bigger pin plug is for charger (for multi-pack only).
2.
Plug the other end of the power adapter & telephone
line cord into the wall jack.
3.
Always use the telephone line cord provided in the box.
4.
Use only the provided power adapter.
Install and charge the handset battery pack
1.
Slide out the battery compartment cover.
2.
Place the supplied rechargeable battery pack in the
battery compartment, with the battery connector
plugged in, as shown.
3.
Slide the battery compartment cover back.
4.
Put the handset on the base to charge for at least 24
hours. When the handset is fully charged the will
indicate that it is fully charged.
5.
Use only the rechargeable battery pack provided.
To Next Page
Loading...
Need help?
General
