UK EN
MODELS:
MBP41S
MBP41S-2
MBP41S-3
MBP41S-4
QUICK START GUIDE
For a full explanation of all features and instructions, please refer to the User’s Guide.
1. Setting up your Digital Video Baby Monitor
• Connect the DC plug of
the power adapter to the
DC jack at the bottom of
the Baby Unit and the
other end to the mains
power.
• Only use the supplied
power adapter (5V DC/
1000mA).
• Slide the ON/OFF switch
to the ON position.
A. Baby Unit Power Supply
DC JACK
DC PLUG
B. Parent Unit Battery Installation
• The rechargeable battery pack supplied
should be installed so that the Parent
Unit can be moved without losing the
link and picture from the Baby Unit(s).
• Charge the battery in the Parent Unit
before you use it for the first time or
when the Parent Unit indicates that
battery is low.
• Insert the wire tabs of the rechargeable
battery pack into the contact slots as
shown and fit the battery pack into the
compartment.
Red
Black
WARNING:
Strangulation Hazard. Children
have STRANGLED in cords. Keep
this cord out of the reach of
children (more than 1 metre
away). Never use extension cords
with AC Adapters. Only use the
AC Adapters provided.
C. Fastening the battery cover of the Parent Unit
• Connect the small plug of the power
adapter to the Parent Unit and the other
end to the mains power.
• Only use the supplied power adapter
(5V DC / 600mA) with the Micro USB
plug.
• Charge for at least 12 hours before first
use.
D. Parent Unit Power Supply
• Place the battery
compartment cover over
the battery, making sure
that the battery wires are
carefully pushed down and
the cover fits properly.
• Gently tighten the screw in
a clockwise direction using
a small cross head or flat
end screwdriver.
Micro USB Socket
Micro USB Plug
To Next Page
Need help?
General
