3 After you click OK, the Wireless Initial Setup page should
appear. Follow the instructions on this page to enter the
network name and password for your original network,
making sure to be accurate and to use the same upper
and lower case characters you used for your original
network.
4 Press Save. You will see a screen confirming your settings.
If you need to, you can correct the settings and press
Save again.
If you encounter a problem, you can restore the factory
modem/router network name and password by pressing the
Reset button on the back of the modem/router for 10 seconds
(a paperclip helps). Those names and passwords are printed
on the bottom label of your MG8702 (and on the photo you
took with your phone).
To Next Page
Loading...
