2 To remove the belt clip, press the belt clip tab
away from the battery using a key. Then slide the
clip upward and away from the radio.
Attaching the Universal Connector Cover
(Dust Cover)
The universal connector is located on the antenna
side of the radio. It is used to connect MOTOTRBO
accessories to the radio.
Insert the slanted end of the cover into the slots
above the universal connector. Press downward on
the cover to seat the dust cover properly on the
Universal Connector.
Secure the dust cover to the radio by pushing the
latch upwards.
To remove the dust cover, push the latch downwards.
Lift the cover up and slide down the dust cover from
the universal connector to remove it.
Replace the dust cover when the universal connector
is not in use.
Attaching the Accessory Connector
The accessory connector is to be secured to the
universal connector on the antenna side of the radio.
1 To attach the accessory connector, refer to the
steps shown in the diagram.
Preparing Your Radio for Use
13
English
To Next Page
Loading...