5
or to Edit Priority and press
to select.
6
or to the required priority level and
press to select.
The display shows before returning to the previous
screen.
Note: The Priority icon appears left of the
member’s name.
There is no Priority icon if priority is set to None.
Scan
When you start a scan, your radio cycles through the
programmed scan list for the current channel looking
for voice activity.
The LED blinks yellow.
There are two ways of initiating scan:
• Main Channel Scan (Manual): Your radio scans
all the channels/groups in your scan list. On
entering scan, your radio may – depending on the
settings – automatically start on the last scanned
“active” channel/group or on the channel where
scan was initiated.
• Auto Scan (Automatic): Your radio automatically
starts scanning when you select a channel/group
that has Auto Scan enabled.
Note: This feature is not applicable in Capacity Plus
and Linked Capacity Plus.
Starting and Stopping Scan
1 Use the Channel Selector Knob to select a
channel programmed with a scan list.
2
to access the menu.
3
or to Scan and press to select.
4
or to Scan State and press to
select.
5
or to required scan state and press
to select.
47
English
To Next Page
Loading...