Receiving and Making Calls
English
18
If Phone Call capability is not enabled in your radio, your radio
mutes the call.
Phone Call as an All Call
Procedure:
When you receive a Phone Call as an All Call:
1 The LED blinks green. Your radio unmutes and the incoming
call sounds through the radio’s speaker.
2 Press the PTT button to talk and release it to listen.
If Phone Call capability is not enabled in your radio, your radio
mutes the call.
NOTE: When you receive a Phone Call as an All Call, you can
respond to the call or end the call, only if an All Call
type is assigned to the channel.
Making a Radio Call
After selecting your channel, you can select a subscriber alias
or ID, or group alias or ID by using:
• The Channel Selector Knob
• A programmed One Touch Access button
NOTE: Your radio must have the Privacy feature enabled on
the channel to send a privacy-enabled transmission.
Only target radios with the same Privacy Key OR the
same Key Value and Key ID as your radio are able to
unscramble the transmission.
See Privacy on page 32 for more information.
The One Touch Access feature allows you to make a
Group or Private Call to a predefined ID easily. This
feature can be assigned to a short or long
programmable button press.You can ONLY have one
ID assigned to a One Touch Access button. Your
radio can have multiple One Touch Access buttons
programmed.
Making a Call with the Channel Selector Knob
Making a Group Call
To make a call to a group of users, your radio must be
configured as part of that group.
NKP_EMEA.book Page 18 Monday, July 30, 2012 9:01 AM
To Next Page
Loading...